You are currently on Page No. 1
Goto Page No. :
| Syllabus for Digital Electronics (BTEC-404) SEC A&B | | The syllabus for 3rd sessionals is:
VHDL and COMBINATIONAL LOGIC using VHDL
Combinational Circuits
1. Adders, Encoders, decoders, MUX and DEMUX
Synchronous and asynchronous counters
Gagandeep Singh Sodhi
Subject Teacher | Posted by Electrical on 18 April 2013 at 09:00 PM |
|
| Revised syllabus for 2nd Sessionals | | D2 Electrical Engineering (Digital Electronics) | Dear students the last chapter for 2nd sessionals has been omitted i.e. VHDL and COMBINATIONAL LOGIC using VHDL. This is for your information.
REVISED SYLLABUS
NUMBER CODES
Error detection and correction codes.
LOGIC GATES
The Inverter, AND ,OR, NAND ,NOR ,Exclusive-OR and Exclusive-NOR Gates
BOOLEAN ALGEBRA AND LOGIC SIMPLIFICATION
1 Boolean Operations and Expressions
2 Laws and Rules of Boolean Algebra
3 DeMorgan's Theorem
4 Boolean Analysis of Logic Circuits
5 Simplification Using Boolean Algebra
6 Standard Forms of Boolean Expressions
7 Boolean Expressions and Truth Tables
8 The Kamaugh Map
9 Karnaugh Map SOP Minimization
10 Karnaugh Map POS Minimization.
Gagandeep Singh Sodhi
Subject teacher | Posted by Electrical on 23 March 2013 at 11:30 AM |
|
| The syllabus for M.Tech(Elect. Engg.) Part Time for sessionals is : | | Introduction
Application of Power Electronics
Types of Switch
Power Semiconductor diodes and characteristics
Diode characteristics, Reverse recovery characteristics, types of power diodes, Series connected diodes and parallel connected diodes + Numericals
Power Transistors
Bipolar junction transistors, Steady state characteristics
The test will be held on 24th April,2013(Sunday).The time and venue will be intimated in a day or two days.
Gagandeep Singh Sodhi
Subject teacher | Posted by Electrical on 19 March 2013 at 08:37 PM |
|
| Syllabus for Digital Electronics (BTEC-404) SEC A&B | | The syllabus for 2nd sessionals is: | NUMBER CODES
Error detection and correction codes.
LOGIC GATES
The Inverter, AND ,OR, NAND ,NOR ,Exclusive-OR and Exclusive-NOR Gates
BOOLEAN ALGEBRA AND LOGIC SIMPLIFICATION
1 Boolean Operations and Expressions
2 Laws and Rules of Boolean Algebra
3 DeMorgan's Theorem
4 Boolean Analysis of Logic Circuits
5 Simplification Using Boolean Algebra
6 Standard Forms of Boolean Expressions
7 Boolean Expressions and Truth Tables
8 The Kamaugh Map
9 Karnaugh Map SOP Minimization
10 Karnaugh Map POS Minimization.
VHDL and COMBINATIONAL LOGIC using VHDL
Gagandeep Singh Sodhi
Subject teacher | Posted by Electrical on 19 March 2013 at 08:17 PM |
|
| Syllabus for Digital Electronics (BTEC-404)SEC A&B | | The syllabus for 1st sessionals is: | Ch-1
Binary Digits, Logic Levels and digital Waveforms (Pg 21)
Timing Diagrams
Basic logic operations (Pg 27)
Overview of basic logic functions
Ch-2
Number systems, operations & codes (Pg 61)
Decimal Numbers
Binary numbers, counting in binary
All conversions
1’s and 2’s complement of binary numbers, signed numbers. Conversion of signed binary no’s. to decimal and vice versa.
Arithmetic operations with signed numbers: Addition and substraction
Binary coded Decimal (BCD) Pg 91
Addition of BCD no’s.
Digital Codes: Gray code
Binary to gray code and vice versa
Gagandeep Singh Sodhi
Subject teacher | Posted by Electrical on 4 February 2013 at 08:05 PM |
|
| Schedule for practical viva-voce of Semiconductor Devices & Circuit Theory on 08-11-12 | | 2nd year Electrical Engineering | 1. Group A1 & A2 (Time: 8.30 a.m. Venue: Applied Electronics Lab)
2. Group B1 & B2 (Time: 10.30 a.m. Venue: Applied Electronics Lab)
All students must bring their practical files.
Gagandeep Singh Sodhi
Subject teacher | Posted by Electrical on 7 November 2012 at 02:26 PM |
|
| Look Out For notes | | D2 EDC | Dear Students,
look out for notes on power Supplies and Power amplifiers pages 6-20 and oscillators on the following blog
www.gssodhi76.blogspot.com
Gagandeep Singh Sodhi | Posted by Electrical on 26 October 2012 at 02:24 PM |
|
| Syllabus for EDC (BTEE-304) | | SEC A &B D2EE | The syllabus for 2nd sessionals is:
Filters
Capacitive filters, L-section filters
Special Purpose diodes
LED’s Principle, Construction, Applications and LED as a circuit element
Schottky diodes and Varactor diodes Principle, Construction and Applications
Bipolar Junction Transistor
Physical Construction, transistor operation and modes of operation. Transistor characteristics and parameters, Common Base, Common Emitter, Common Collector Configurations.
Gagandeep Singh Sodhi
Subject teacher | Posted by Electrical on 24 September 2012 at 09:56 AM |
|
| Syllabus for Power Electronics (PEE-503) | | M.Tech(1st Sem) | The syllabus (SECTION A) for 2nd sessionals is :
MM 15
Power Semiconductor diodes and characteristics
Diode characteristics, Reverse recovery characteristics, types of power diodes, Series connected diodes and parallel connected diodes
Power Transistors
Bipolar junction transistors, Steady state characteristics, Switching chracteristice and switching limits
Gagandeep Singh Sodhi
Subject teacher | Posted by Electrical on 23 September 2012 at 08:39 PM |
|
| Congratulations | | On the behalf of Electrical Engineering Department we express our heartiest congratulations and immense pride on the final selection of the under mentioned students
from B.Tech. Electrical Engg.by Shapoorji Pallonji & Company limited.
1. Amrinder
2. Diljeet Singh
3. Jasneet Kaur
4. Jayshree Sharma
5. Rakinder Kaur
6. Ratinderjit Kaur
7. Tarun Chaudhary
It is a success, you truly deserved. It is an achievement you all have truly earned.
We congratulate you on your success and wish you all the best for your future. Well done!
We also express our gratitude to T&P cell.Without their efforts this wouldn't have been possible.
Gagandeep Singh and Harmeet Singh
Department Training Placement Coordinators | Posted by Electrical on 24 August 2012 at 08:29 PM |
|
| Final Year Electrical Engg. Students | | NOTICE | 1. The final viva voce examination of six months industrial training will be held on 4th May,2012.
2. There will be group photograph on the same day at 12.30pm in the department.
3.Students may bring their no due forms and get them signed from faculty.
Gagandeep Singh Sodhi
(Deptt Placement Coordinator) | Posted by Electrical on 2 May 2012 at 03:20 PM |
|
| Notice | | Second year students | Dear students,
Look out for notes on oscillators on the following blog.
www.gssodhi76.blogspot.com
all the best
gagandeep singh sodhi
subject teacher | Posted by Electrical on 14 April 2012 at 11:39 PM |
|
| NOTICE | | Syllabus for 3rd sessional (Applied Electronics) | Power Amplifiers
Types of power amplifiers,difference between small signal and power amplifiers,Class A amplifier, series fed or direct coupled,trnasformer coupled,Distortion in amplifiers,2nd order harmonic distortion, Class A Push Pull amplifier, Class B power amplifier,complementary symmetry circuit, Cross over distortion.
Gagandeep Singh Sodhi
(Subject Teacher) | Posted by Electrical on 3 April 2012 at 09:11 PM |
|
| Regarding submission of general fitness form | | dear students of section B2 3rd year and A2 2nd year(EE),
you are required to submit the general fitness form duly filled to the undersigned latest by thursday(5th April,2012).
Note: Further delay will not be entertained.
Gagandeep Singh Sodhi,
Advisor | Posted by Electrical on 3 April 2012 at 12:51 PM |
|
| NOTICE | | Reagrding Username and Password | | All the students of Electrical Engineering Branch (2nd yr onwards) may collect their usernameID's and password for net access from Mrs. Harjinder kaur in the Electrical Deptt office during working hours. | Posted by Electrical on 15 February 2012 at 10:00 PM |
|
| Applied Electronics (D2EE) | | Format for Question Paper( 3rd Test) | The format for question paper will be as follows:
1. The test will be of 24 marks and time allowed will be 90 minutes.
2. All questions will be compulsory.
3. short answer questions (2,3,3,3 marks each).
4. Short answer questions each of 4 marks. (8 marks).
5. One long question of 5 marks
6. All the questions will be from the syllabus covered in the class.
6. This time there will be no numericals.
All the best.
Gagandeep Singh Sodhi
Subject teacher | Posted by Electrical on 31 January 2012 at 10:43 PM |
|
| Syllabus for Applied Electronics (1st Sessional) | | The syllabus for 1st sessional D2 Electrical Engineering Students is as under:-
Transistor hybrid model,determination of h-parameters, derivations for determination of h parameters for one configuration in terms of h parameters of other configuration, analysis of amplifier(transistor) using h parameters, comparison(graphically) of transistor amplifier configurations,linear analysis of a transistor circuit and physical model of CB transistor.
the format for question paper will be intimated later on.
Gagandeep Singh | Posted by Electrical on 23 January 2012 at 10:30 PM |
|
| 6 months industrial training | | This refers to letter from TP cell regarding confirmation of 6 months industrial training. It is further submitted that all the students are required to submit the name of the company in which they are most likely to undertake their 6 months training.The names must be submitted to the TPO or department training and placement coordinators latest by 30.10.2011.
Gagandeep Singh Sodhi Harmeet Singh Gill | Posted by Electrical on 16 October 2011 at 10:08 PM |
|
| Submission of Photograph | | The following list of students ( Roll No.)have not submitted their photograph for I-Cards .
92043,92149
82011,82072,82083,82092,82096,82116,82119,82126,82097,82083
They are required to submit their photograph (PP Size) latest by monday (17.10.2011)
H.O.D. | Posted by Electrical on 13 October 2011 at 03:43 PM |
|
| Seminar | | This is for the information of all final year students that EE Dept. is organising a seminar on group discussions & personal Interview on 12th October,2011. at 2.00pm in consultancy seminar hall by an expert advisor. All students are directed to attend the same .
H.O.D.
Elect. Engg. Deptt. | Posted by Electrical on 12 October 2011 at 10:18 AM |
|
| Identity Cards of Electrical Engineering Branch | | All the students of B.tech and M.tech whose ID card's have not been made are required to submit ID card details and one PP size photograph in the office of Electrical Engineering Department latest by 7th Oct, 2011.
Gagandeep Singh Sodhi | Posted by Electrical on 4 October 2011 at 07:47 PM |
|
Designed by:
Department of CSE & IT |